高输出功率小瞬时电流可靠性试验报告仪（耐弧光可靠性试验报告仪）-（换算机调整）

High voltage low current tester (arc resistance tester) - (computer control)

货产品称呼称：耐电弧试验机

Product name: electric arc resistance tester

软件参数：NDH-A

Product model: NDH - A

无法标：GB/T 1411-2002《粉状电绝缘村料耐高压得很低工作电流弧光发出电的检验》（等同于IEC  61621-1997）及ASTM D495等标准规范的条件开发生产的，并适合IEC 149、UL 746A等试验检测策略

Meet the standards: GB/T 1411-1411 "solid insulating material resistant to high voltage low current arc discharge test" (equivalent to IEC 61621-1997) and the requirements of standards such as ASTM D495 design and manufacturing, and conform to the IEC 149, UL 746 a test method, etc

一 概述

一An overview of the

其主要适宜超范围及能力：

本试验检测机是假设按照适主要用于直流电机、电气和挂式电气等业内的安装电工用金属、聚酯光敏树脂胶和电接地层漆等电接地层原素材的耐电孤功效指标评定标准，主主要用于固态垃圾电接地层原素材如：金属、贴膜、聚酯光敏树脂、云母片、工业陶瓷、夹层玻璃、电接地层油、电接地层漆、纸箱等物质的耐电孤功效指标測試；

本可靠性實驗机由计算公式机保持运营，可表示某些實驗情况及實驗时长，實驗尾声后并存为某些實驗数据文件，并可印刷.基准研究报告模板。

Main scope of application and features:

This machine is in accordance with the applied in motor, electrical appliances and household appliances and other industries with varnish insulation materials such as plastic, resin adhesive and the arc resistance evaluation, the main used for solid insulating material such as plastic, film, resin, mica, ceramic, glass, insulating oil, insulating paint, such as cardboard medium arc resistance test;

This testing machine controlled by computer operation, can display the current experimental condition and experimental time, after the experiment, and save the current experimental data and can be printed. Standard experiment report 

二 功能特点

1 滤油机为上上下下成一体空间结构，下端为进行系统的，上方为可靠性湿热试验箱。

2 本企业产品主要包括*新智力把控能力，能够 选择程序流程图（IEC或ASTM）可电脑自动对其进行试验检测，并在手提我的电脑凸显做实验的时候期间和最后。

3 **特性优异，抗干拢水平强，测验精密度更高。

二：Functional features：

1 this machine is up and down a body structure, lower for the operating system, the upper part of test cases.

2 this product USES the latest intelligent control technology, through the selection process (IEC) or ASTM test can be automatically, and displayed on the computer and the test process and results.

3 good safety performance, strong anti-interference ability, high test precision. 

三 主要技术参数

1 焊弧通断事件误差度：低于 ±10ms

2 调压器存储空间：2kVA

3 特殊实验电阻值：12.5kV

4 实验电压降gps精度：±3%

5 瞬时电流调控误差：±10%  电流值測量精密度：1.5%

6 电极材料对坯料压为：（0.5±0.05）N

7 金属电极板材：钨棒

8 金属电极间隔：（6.35±0.1）mm（IEC）

               （6.0±0.1）mm（ASTM）

9 运用环境平均温度：（23±2）℃

10 应用区域水分子含量：（50±5）%

11 电源开关：220V±5%  50Hz  10A

12 现场实验    形式：   行业标准/美标/10 mA 间断性/20 mA 接连/30 mA间隔/40 mA多次

13 经过多次实验发现应用程序下述：

Three main technical parameters：

Error: 1 arc on-off time less than plus or minus 10 ms

Transformer capacity: 2 kva

3 test voltage rating: 12.5 kV

4: test voltage accuracy + / - 3%

5 current control accuracy: plus or minus 10% current measuring accuracy: 1.5%

6 electrode pressure on sample: (0.5 + 0.5) N

7 electrode materials: tungsten rods

8 electrode distance: 6.35 + / - 0.1 mm (6.0 + 0.1) mm (IEC) (ASTM)

9 using the environment temperature (23 + 2) ℃

10 use environment humidity: (50 + 5) %

Power supply: 220 v + 5% for 50 hz 10 a

Test method: beautiful mark / 10 gb / 30 mA mA continuous / 20 mA continuous/continuous / 40 mA continuous

13 test procedure is as follows:

Procedures section of the arc current

MA arc on-off time s the program s test total duration time s

IEC 61621 ASTM D495

1 1/8 10 s on 7/8 s broken 1/4 7/4 break 60 s 60 s

2 10 1/4 "s pass 3/4 s 1/4 3/4 break 60 s 120 s

3 to 10 1/4 "s make a quarter s break a quarter of a quarter break 60 s 180 s

4 consecutive 10 to 60, 240

5 20 consecutive 60, 300

30 consecutive 6 to 60, 360

7 consecutive 40 to 60, 420 

四  配置

Four configuration：

Serial number name number note

01 arc resistance tester

02 a electrode system

03 electrode bearing a set

04 a set of power cable

05 ground put a rod

06 milliammeter current one

7 a set of computer measurement and control software

08 specimen holder a

09 electrode distance standard 2 blocks

Standard 2 blocks of 10 Angle

11 ceramic pieces 2 pieces

12 one brand inkjet printer

13 1 computer brand

14 1 instruction manual

15 1 certificate

五 设备尺寸：

NDH-A    耐电孤耐压试验仪-微机抑制

NDH-B    耐电弧放电耐压仪-摸屏设定

Five product model:

NDH - A arc resistance tester - microcomputer control

NDH - B arc resistance tester - touch screen control
ASTMD495耐高压低电流电弧放电试验机详情可以随时来电咨询！